H3C Technologies H3C Intelligent Management Center - Manual (Page 463)

449
traffic at the specific time point. Click Rx or Tx to display or hide the corresponding monitor index
in the graph.
• Attribute/Value—Monitor index name and data that was obtained when APM last polled POP3.
{
Last Hour's Traffic—Total traffic sent and received by POP3 over the last 1 hour.
{
Today's Traffic—Total traffic sent and received by POP3 since 00:00 today.
SMTP
Simple Mail Transfer Protocol (SMTP) is an Internet standard protocol for email transmission between
source and destination addresses. Most mail servers support SMTP.
Adding an SMTP application monitor
APM monitor the SMTP application through the SMTP service port (25 by default). Before adding an
SMTP application monitor, follow these guidelines:
• Add the host that provides the SMTP service to be monitored to the IMC platform.
For a host managed in the IMC platform, APM obtains and displays network connections of the
host and its access device in the application topology. For information about adding hosts to the
IMC platform, see H3C IMC Base Platform Administrator Guide.
• Obtain the email address and mailbox account information to test the SMTP service by using APM
as an email client.
• To view traffic statistics in the monitor report of the SMTP application, make sure at least one probe
is configured in APM. After an SMTP application monitor is added, APM sends the IP address and
service ports of the monitored SMTP application to the probes for traffic collection.
To add an SMTP application monitor:
1. Click the Resource tab.
2. Enter the Add Application page in one of the following ways:
{
From the navigation tree, select Application Manager > Add Application.
{
From the navigation tree, select Application Manager > Application Monitor, and click Add on
the application monitor list page.
The page displays all application types that can be monitored by APM.
3. Click SMTP of the Mail Server Monitor class.
The page for adding an SMTP application monitor appears.
4. Configure the following parameters for the application monitor:
{
IP Address—Enter the IP address of the host on which the SMTP application to be monitored is
installed. APM automatically checks the IP address and associates the application monitor with
the host if it is already managed in the IMC platform. To monitor a host that is already managed
in the IMC platform, you can also click Select and select the host in the Select Devices window.
For information about selecting a host, see " 2 Quick start ."
{
Name—Enter a unique application monitor name. H3C recommends naming the application
monitor as Application name_host IP address.
{
Use Template—Select Enable or Disable from the list.