H3C Technologies H3C WA3600 Series Access Points - Manual (Page 99)

86
The page in Figure 83 appears.
b. Select the destination IP address type as IPv4/Domain, enter the destination address 1.1.1.2,
enter the user name user1, and select v3 from the Security Model list.
c. Click Apply.
Figure 83 Add target hosts of SNMP traps
Configuring the NMS
CAUTION:
The NMS must have the same configuration as the agent. Otherwise, you cannot perform corresponding
operations.
SNMPv3 adopts a security mechanism of authentication and privacy. You must configure the username
and security level. According to the configured security level, you must configure the related
authentication mode, authentication password, privacy mode, privacy password, and so on.
You must also configure the aging time and retry times. After these configurations, you can configure the
device as needed through the NMS. For more information about NMS configuration, see the manual
provided for NMS.
Verifying the configuration
• After the above configuration, the NMS and the agent establish an SNMP connection. The NMS
can get and configure the values of some parameters on the agent through MIB nodes.
• If an idle interface on the agent is shut down or brought up, the NMS can receive a trap message
from the agent.