H3C Technologies H3C WA3600 Series Access Points - Manual (Page 444)

431
User isolation
If an AP has the user isolation feature enabled, clients associated with it are isolated at Layer 2.
As shown in
Figure 466 , after user isolation is enabled on the AP, all the clients cannot ping each other
or learn each other's MAC or IP addresses, because they cannot exchange Layer 2 packets.
Figure 466 Network diagram
Configuring user isolation
1. Select Security > User Isolation from the navigation tree.
Figure 467 Configuring user isolation
2. Configure user isolation as described in Table 147 .
3. Click Apply.
Table 147 Configuration items
Item Description
User Isolate
• Enable—Enable user isolation on the AP to isolate the clients associated with it
at Layer 2.
• Disable—Disable the user isolation.
By default, wireless user isolation is enabled.