Displaying the ipv6 active route table – H3C Technologies H3C WA3600 Series Access Points User Manual
Page 130
117
Item Description
Interface
Select the outgoing interface.
You can select any available Layer 3 interface, for example, a virtual
interface, of the device. If you select NULL 0, the destination IP address is
unreachable.
If you select this option, do not enter any IP address in the Next Hop field.
Otherwise, the configuration does not take effect.
Displaying the IPv6 active route table
Select Network > IPv6 Routing from the navigation tree to enter the page shown in
.
Figure 119 IPv6 active route table
Table 55 Field description
Field Description
Destination IP Address
Destination IP address and prefix length of the IPv6 route.
Prefix Length
Protocol
Protocol that discovered the IPv6 route.
Preference
Preference value for the IPv6 route.
The smaller the number, the higher the preference.
Next Hop
Next hop IP address of the IPv6 route.
Interface
Outgoing interface of the IPv6 route. Packets destined for the
specified network segment will be sent out the interface.