beautypg.com

Configuration guidelines, Wds configuration examples, Wds configuration example – H3C Technologies H3C WA3600 Series Access Points User Manual

Page 350: Network requirements, Configuring ap 1

background image

337

Configuration guidelines

Note the following guidelines when you configure 802.11n:

Select Radio > Radio from the navigation tree, select the AP radio unit to be configured, and click
the corresponding

icon to enter the radio configuration page, where you can modify the

802.11n-related parameters, including Bandwidth Mode, A-MSDU, A-MPDU, Short GI, and Client
802.11n Only (permitting only 802.11n users to access the wireless network).
Make sure 802.11n(2.4GHz) is enabled.

Select Radio > Rate from the navigation tree to modify the 802.11n rate.

WDS configuration examples

WDS configuration example

Network requirements

In an outdoor environment as shown in

Figure 365

, connecting the two LAN segments with cables is

time-consuming and cost ineffective. Therefore, you can connect the two LAN segments with a WDS link.

Connect AP 1 and AP 2 to different LAN segments.

Configure AP 1 and AP 2 to use channel 153 to establish the 802.11n(5GHz) WDS link.

Configure preshared key 12345678 to ensure WDS link security.

Figure 365 Network diagram

Configuring AP 1

1.

Assign an IP address to AP 1:

a.

Select Network > VLAN to create a VLAN on AP 1.

b.

Select Device > Interface Management to assign an IP address to the VLAN interface.

2.

Configure WDS:

a.

Select Wireless Service > WDS from the navigation tree to enter the WDS Setup page.

This manual is related to the following products: