H3C Technologies H3C WA3600 Series Access Points - Manual (Page 311)

298
b. Click Add.
c. On the page that appears, enter the service name office, select the wireless service type clear,
and click Apply.
d. On the page that appears, enter 3 in the VLAN (Untagged) field, enter 3 in the Default VLAN
field, enter 1 in the Delete VLAN field, and click Apply.
Before you perform these VLAN settings, select Network > VLAN to create VLAN 3 first.
Figure 302 Set the VLANs
NOTE:
For wireless access configuration, see " Wireless access configuration examples ." You can follow the
wireless access configuration examples to configure wireless access.
Verifying the configuration
• The client can successfully associate with the AP and access the WLAN network.
• You can view the online clients on the page you enter by selecting Summary > Client from the
navigation tree.
Figure 303 View the online clients
The page shows that the client 0014-6c8a-43ff, which accesses the SSID office, is in VLAN 3, while the
client 0040-96b3-8a77, which accesses the SSID research, is in VLAN 2. The two clients are in different
VLANs, so they cannot access each other.
WPA-PSK authentication configuration example
Network requirements
As shown in Figure 304 , it is required that the client access the wireless network by passing PSK
authentication. The WPA-PSK key configuration on the client is the same as that on the AP, that is,
12345678.