H3C Technologies H3C WA3600 Series Access Points - Manual (Page 159)

146
Configuring the PPPoE client
1. Create a PPPoE client:
a. Select Network > PPPoE from the navigation tree.
The system automatically enters the Client page.
b. Click Add to enter the page shown in Figure 153 .
c. To create a PPPoE client:
Enter 1 as the dialer interface name.
Enter user1 as the username.
Enter hello as the password.
Select the IP configuration mode PPP Negotiate.
Select the interface to be bound Vlan-interface1.
Select the session type Always Online.
d. Click Apply.
Figure 153 Create a PPPoE client
Configuring the PPPoE server
You must enable the PPPoE protocol on the PPPoE server, configure the PPPoE username and password
that are the same as those configured on the PPPoE client, and assign an IP address to the peer end of
the PPP connection. Detailed configurations are not discussed here.
Verifying the configuration
Display the summary information of PPPoE sessions on an AP.