H3C Technologies H3C WA3600 Series Access Points - Manual (Page 430)

417
Figure 451 Testing channel busy rate
3. Configure channel busy test as described in Table 139 .
4. Click Start.
Table 139 Configuration items
Item Description
Radio Unit Display the radio unit of the AP.
Radio Mode Display the radio mode of the AP.
Test time per channel
Set a time period in seconds within which a channel is tested.
The value defaults to 3 seconds.
NOTE:
Before the channel busy test completes, do not start another test for the same channel.
Configuring band navigation
NOTE:
•
When band navigation is enabled, the client association efficiency is affected, so this feature is not
recommended in a scenario where most clients use 2.4 GHz.
• Band navigation is not recommended in a delay-sensitive network.
• Support for the band navigation depends on the device model. For more information, see "Feature
matrix."
Configuration prerequisites
To enable band navigation to operate properly, make sure of the following: