H3C Technologies H3C WA3600 Series Access Points - Manual (Page 134)

121
IPv6 static route configuration example
Network requirements
The IP addresses of devices are shown in Figure 123 . IPv6 static routes must be configured on Switch A,
Switch B and AP for Host A and Host B to communicate with each other.
Figure 123 Network diagram
Configuration outlines
1. On Switch A, configure a default route with Switch B as the next hop.
2. On Switch B, configure one static route with Switch A as the next hop and the other with AP as the
next hop.
3. On AP, configure a default route with Switch B as the next hop.
Configuration procedure
1. Specify gateway 1::1 for Host A and gateway 3::1 for Host B.
2. Configure a default route with the next hop address 4::2 on Switch A.
3. Configure a static route with destination address 1::/64 and next hop address 4::1 on Switch B.
4. Configure a default route on AP.
a. Select Network > IPv6 Routing from the navigation tree
b. Click the Create tab to enter the IPv6 static route configuration page, as shown in Figure 124 .
c. Enter destination IP address ::, select prefix length 0, and enter next hop 3::3.
d. Click Apply.