Configuring the radius server (imcv3) – H3C Technologies H3C WA3600 Series Access Points User Manual
Page 333
320
b.
Click the Bind link at the right side of the wireless service mac-auth to enter the page as shown
c.
Select the box with radio mode 802.11n(2.4GHz).
d.
Click Bind.
Figure 340 Bind an AP radio
7.
Enable the wireless service
a.
Select Wireless Service > Access Service from the navigation tree.
b.
On the page that appears, select the dot1x box and click Enable.
Figure 341 Enable the wireless service
8.
Optional: Enable 802.11n radio (By default, 802.11n radio is enabled.)
Select Radio > Radio from the navigation tree to enter the Radio page. Make sure 802.11n is
enabled.
Configuring the RADIUS server (iMCv3)
NOTE:
•
The following takes the iMC (iMC PLAT 3.20-R2602 and iMC UAM 3.60-E6102) as an example to
illustrate the basic configuration of the RADIUS server.
•
A license has been installed on the server.
1.
Add access device.
a.
Select the Service tab in the iMC platform.
b.
Select Access Service > Access Device from the navigation tree.
c.
Click Add.