H3C Technologies H3C WA3600 Series Access Points - Manual (Page 136)

123
0.00% packet loss
round-trip min/avg/max = 62/62/63 ms
Configuration guidelines
When you configure a static route, follow these guidelines:
1. If you do not specify the preference when you configure a static route, the default preference is
used. Reconfiguration of the default preference applies only to newly created static routes. The
web interface does not support configuration of the default preference.
2. When you configure a static route, the static route does not take effect if you specify the next hop
address first and then configure it as the IP address of a local interface, such as an Ethernet
interface and VLAN interface.
3. When specifying the output interface, note that:
• If NULL 0 or a loopback interface is specified as the output interface, there is no need to configure
the next hop address.
• If a point-to-point interface is specified as the output interface, do not specify the next hop or
change the configuration after the peer address has changed. For example, a PPP interface obtains
the peer's IP address through PPP negotiation, and therefore, you only need to specify it as the
output interface.