H3C Technologies H3C WA3600 Series Access Points User Manual
Page 77
64
1.
Select Device > TR-069 from the navigation tree.
The TR-069 configuration page appears.
Figure 57 TR-069 configuration page
2.
Configure TR-069 parameters described in
.
3.
Click Apply.
Table 32 Configuration items
Item Description
TR-069
Enable or disable TR-069.
TR-069 configurations can take effect only after you enable TR-069.
ACS
URL.
Configure the URL used by a CPE to initiate a connection to the ACS.
Username.
Configure the username used by a CPE to initiate a connection to the ACS.
Password.
Configure the password used by a CPE to initiate a connection to the ACS.
You can specify a username without a password that is used in the authentication.
If so, the configuration on the ACS and that on the CPE must be the same.
CPE
Username.
Configure the username used by the CPE to authenticate the connection sent from
the ACS.
Password.
Configure the password used by the CPE to authenticate the connection sent from
the ACS.
You can specify a username without a password that is used in the authentication.
If so, the configuration on the ACS and that on the CPE must be the same.
Sending
Inform.
Enable or disable CPE's periodical sending of Inform messages.
Interval.
Configure the interval between sending the Inform messages.
Account
Maintenance.
Enable or disable the CPE to inform the ACS to change the password of the account
TelecomAdmin.
CPE Interface.
Set the CPE connection interface. The CPE sends inform packets carrying the IP
address of this interface to make the ACS establish a connection with the CPE using
this IP address.