2 power-up/reset sequence, Figure 3-3, Example cavium cn5860 monitor start-up display – Artesyn ATCA-9305 User's Manual (May 2014) User Manual

Page 77

Cavium Processor Complex

ATCA-9305 User’s Manual (10009109-07)

attempts to load the application from the specified device. If the monitor is not configured for
autoboot or a failure occurs during power-up, the monitor enters normal command-line mode.
The monitor command prompt in

Figure 3-3

is the result of a successful hardware boot of the

ATCA-9305.

3.4.2

Power-up/Reset Sequence

The Cavium CN5860 processor follows the boot sequence in

Figure 3-4

before auto-booting

the operating system or application software. At power-up or board reset, the monitor
performs hardware initialization, diagnostic routines, autoboot procedures, and if necessary,
invokes the command line. See

Table 3-6

for default Cavium environment variables settings.

Figure 3-3

Example Cavium CN5860 Monitor Start-up Display

There will be either a 1 or 2 in front of the monitor prompt indicating which Cavium processor
is prompting.