8 get handle switch, 9 set handle switch, 8 get handle switch 7.11.9 set handle switch – Artesyn ATCA-9305 User's Manual (May 2014) User Manual
Page 177: Table 7-24, Get handle switch command, Table 7-25, Set handle switch command, System management

System Management
ATCA-9305 User’s Manual (10009109-07)
177
7.11.8 Get Handle Switch
The Get Handle Switch command reads the state of the Hot Swap handle of the IPMC.
Overriding of the handle switch state is allowed only if the IPMC operates in (Manual)
Standalone mode.
7.11.9 Set Handle Switch
The Set Handle Switch command sets the state of the Hot Swap handle switch in (Manual)
Standalone mode.
Table 7-24 Get Handle Switch Command
Type
Byte
Data Field
Request Data
1:3
PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Response Data
1
Completion Code
2:4
PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
5
Handle Switch Status
0x00 The handle switch is open
0x01 The handle switch is closed
0x02 The handle switch state is read from hardware
Table 7-25 Set Handle Switch Command
Type
Byte
Data Field
Request Data
1:3
PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
4
Handle Switch Status
0x00 The handle switch is open
0x01 The handle switch is closed
0x02 The handle switch state is read from hardware