beautypg.com

3 set serial interface properties, Table 7-19, Set serial interface properties command – Artesyn ATCA-9305 User's Manual (May 2014) User Manual

Page 173: System management

background image

System Management

ATCA-9305 User’s Manual (10009109-07)

173

7.11.3 Set Serial Interface Properties

The Set Serial Interface Properties command is used to set the properties of a particular serial
interface.

Table 7-19 Set Serial Interface Properties Command

Type

Byte

Data Field

Request Data

1:3

PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)

4

Interface ID
0 Serial Debug Interface
1 Payload Interface

5

Bit [7] Echo On
If this bit is set, the IPMC enables echo for the given serial interface
Bits [6:4] reserved
Bits [3:0] Baud Rate ID
The baud rate ID defines the interface baud rate as follows:
0 9600 bps
1 19200 bps
2 38400 bps
3 57600 bps (unsupported)
4 115200 bps (unsupported)

Response Data

1

Completion Code

2:4

PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)