beautypg.com

3 hot swap – Artesyn ATCA-9305 User's Manual (May 2014) User Manual

Page 66

background image

Setup

ATCA-9305 User’s Manual (10009109-07)

66

2.3.3

Hot Swap

The ATCA-9305 can be Hot Swapped, as defined in the AdvancedTCA specification (see
reference in

Table A-2

). This section describes how to insert and extract an ATCA-9305 module

in a typical AdvancedTCA system. (These procedures assume the system is using a shelf
manager.)

Insert a board

1. Insert the ATCA-9305 into an available slot.

2. Push in the front panel handle (tab).

The blue Hot Swap LED on the front panel (see

Figure 2-1

) flashes a long blink to indicate that

board insertion is in progress and system management software is activating the slot. Then the
blue LED turns off, indicating the insertion process is complete, and payload power is present.

The ATCA-9305 Rear Transition Module (RTM) has its own Hot Swap LED and switch, and it
can be Hot Swapped in/out independently of the front board. If the front board is not present,
then the RTM will not be powered. If the front board is Hot Swapped out, the RTM’s blue LED
will illuminate. In either case, the RTM can be safely removed.

Personal Injury or Product Damage

The product is supplied by a TNV-2 voltage. This voltage is considered hazardous. Make sure
that the external power supply meets the relevant safety standards.

Make sure that TNV-2 is separated from dangerous voltages (mains) through double or
reinforced insulation.