6 get hardware address, 7 set hardware address, 6 get hardware address 7.11.7 set hardware address – Artesyn ATCA-9305 User's Manual (May 2014) User Manual
Page 176: Table 7-22, Get hardware address command, Table 7-23, Set hardware address command, System management

System Management
ATCA-9305 User’s Manual (10009109-07)
176
7.11.6 Get Hardware Address
The Get Hardware Address command reads the hardware address of the IPMC.
7.11.7 Set Hardware Address
The Set Hardware Address command allows overriding of the hardware address read from
hardware when the IPMC operates in (Manual) Standalone mode.
Table 7-22 Get Hardware Address Command
Type
Byte
Data Field
Request Data
1:3
PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Response Data
1
Completion Code
2:4
PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
5
Hardware Address
Table 7-23 Set Hardware Address Command
Type
Byte
Data Field
Request Data
1:3
PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
4
Hardware Address
If set to 00, the ability to override the hardware address is disabled
NOTE: A hardware address change only takes effect after an IPMC reset.
See “Reset IPMC” on page 7-34.
Response Data
1
Completion Code
2:4
PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)