Artesyn ATCA-9305 User's Manual (May 2014) - Manual (Page 149)

System Management
ATCA-9305 User’s Manual (10009109-07) 149
The IPMC implements many standard IPMI commands. For example, software can use the
watchdog timer commands to monitor the system’s health. Normally, the software resets the
watchdog timer periodically to prevent it from expiring. The IPMI specification allows for
different actions such as reset, power off, and power cycle, to occur if the timer expires. The
watchdog’s ‘timer use’ fields can keep track of which software (Operating System, System
Management, etc.) started the timer. Also, the time-out action and ‘timer use’ information can
be logged automatically to the System Event Log (SEL) when the time-out occurs. Refer to the
IPMI specification (listed in
Table A-2 ) for details about each command’s request and response
data. The IPMC also implements ATCA commands, see the ATCA Base Specification (PICMG
3.0).
FRU Control PICMG 2C, 2D 04
Get FRU LED Properties PICMG 2C, 2D 05
Get LED Color Capabilities PICMG 2C, 2D 06
Set FRU LED State PICMG 2C, 2D 07
Get FRU LED State PICMG 2C, 2D 08
Set IPMB State PICMG 2C, 2D 09
Set FRU Activation Policy PICMG 2C, 2D 0A
Get FRU Activation Policy PICMG 2C, 2D 0B
Set FRU Activation PICMG 2C, 2D 0C
Get Device Locator Record ID PICMG 2C, 2D 0D
Set Port State PICMG 2C, 2D 0E
Get Port State PICMG 2C, 2D 0F
Compute Power Properties PICMG 2C, 2D 10
Set Power Level PICMG 2C, 2D 11
Get Power Level PICMG 2C, 2D 12
Bused Resource
(Release, Query, Force, Bus Free) PICMG 2C, 2D 17
Table 7-5 IPMC IPMI Commands (continued)
Command netFn LUN Cmd