Artesyn ATCA-9305 User's Manual (May 2014) - Manual (Page 179)

System Management
ATCA-9305 User’s Manual (10009109-07) 179
7.11.11 Set Payload Communication Time-Out
The Set Payload Communication Time-Out command sets the payload communication time-
out value.
7.11.12 Enable Payload Control
The Enable Payload Control command enables payload control from the Serial Debug interface.
Table 7-27 Set Payload Communication Time-Out Command
Type Byte Data Field
Request Data 1:3 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
4 Payload Time-out
Payload communication time-out measured in hundreds of
milliseconds. Thus, the payload communication time-out may vary from
0.1 to 25.5 seconds.
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Table 7-28 Enable Payload Control Command
Type Byte Data Field
Request Data 1:3 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)