beautypg.com

Table 9-7, Optional environment variables, Management processor monitor – Artesyn ATCA-9305 User's Manual (May 2014) User Manual

Page 262

background image

Management Processor Monitor

ATCA-9305 User’s Manual (10009109-07)

262

The monitor supports optional environment variables that enable additional functionality. The
moninit command (see “

moninit

”) clears all environment variables and sets the standard

environment variables to the default values. All optional environment variables are removed
after moninit. However, it can clear all optional variables.

preboot

undefined

Command to execute immediately before starting the
CONFIG_BOOTDELAY countdown and/or running the auto-boot
command entering the interactive mode

rootpath

eng/
emerson/

Path name of the NFS’ server root file system

serial#

xxxxx

Board serial number

serverip

0.0.0.0

Boot server IP address

tftp_port

eTSEC_1

Selects which Ethernet port will be used for tftp
Valid options: eTSEC_1, eTSEC_2

Table 9-7 Optional Environment Variables

Variable

1

Description

app_lock_base

Assigns where to start block lock protection at the base of NOR (soldered)
flash. If assigned region does not fall within the NOR flash area, no
user/application locking will occur, except for the monitor block-locking
protection.

app_lock_size

Size of user NOR (soldered) flash protection area.

bootverifycmd

Sets the U-Boot boot command that is used to execute the primary and
secondary application images when using the bootv command. If not defined,
bootv uses the U-Boot go command as the default.

carrier_num

This is a slot within a shelf defined by the zone 1 hardware address
corresponding to the logical slot address.

e_keying

Determines whether switch ports should be configured.

The moninit command does not initialize these variables. Each parameter is only defined if a change
from the default setting is desired and is not defined after initialization of the environment variables.

Table 9-6 Standard Environment Variables (continued)

Variable

Default
Value

Description