beautypg.com

15 mpc8548 environment variables, Table 9-6, Standard environment variables – Artesyn ATCA-9305 User's Manual (May 2014) User Manual

Page 260: Mpc8548 environment, Variables, If the c, Mpc8548, Environment variables, Mpc8548 environment variables, Management processor monitor

background image

Management Processor Monitor

ATCA-9305 User’s Manual (10009109-07)

260

9.15 MPC8548 Environment Variables

Press the ‘s’ key on the keyboard during reset to force the default monitor environment
variables to be loaded during hardware initialization but before diagnostic testing.

Table 9-6 Standard Environment Variables

Variable

Default
Value

Description

baudrate

9600Bd

Console port baud rate
Valid rates: 9600, 14400, 19200, 38400, 57600, 115200
Note: The older firmware used the default baud rate as 115kBd
and also the Octeon console stays with 115kBd.

bmc_wd_timeou

t

-1

This sets the time-out in seconds for the BMC watchdog before
booting the OS. If set to -1, then the BMC watchdog is disabled
before booting the OS.
Valid options: -1, 1-65535

bootcmd

" "

Command to execute when auto-booting or executing the
‘bootd’ command

bootdelay

1

Choose the number of seconds the Monitor counts down before
booting user application code
Valid options: time in seconds, -1 to disable autoboot

bootfile

" "

Path to boot file on server (used with TFTP)–set this to
“path/file.bin” to specify filename and location of the file to load.

bootretry

-1

Set the number of seconds the Monitor counts down before
booting user application code (used only with autoboot). If the
boot commands fails, it will try again after bootretry seconds.
Valid options: time in seconds, -1 to disable bootretry

bootstopkey

h

Press during power-up/reset initialization to terminate the
monitor autoboot sequence and go to the monitor prompt.

clearmem

on

Select whether to clear unused SDRAM (memory used by
monitor is excluded) on power-up and reset.
Valid options: on, off

dcache

on

Enables the processor L1 data cache
Valid options: on, off

ecc

on

Enable ECC initialization–all of memory is cleared during ECC
initialization. Valid options: on, off