Artesyn ATCA-9305 User's Manual (May 2014) - Manual (Page 134)

Ethernet Interface
ATCA-9305 User’s Manual (10009109-07) 134
00 80 F9 xx yy zz
00 80 F9 is Artesyn’s identifier. The last three bytes of the Ethernet address consist of the port
(one byte), 0x97(port 1) or 0x98 (port 2), followed by the serial number (two byte
hexadecimal). The ATCA-9305 has been assigned the Ethernet address range
00:80:F9:97:00:00 to 00:80:F9:98:FF:FF. The format is shown in
Table 6-3 .
The last two bytes, MAC[15:0], correspond to the following formula: n –1000, where n is the
unique serial number assigned to each board. So if an ATCA-9305 serial number is 1032, the
calculated value is 32 (20
16
), and the default Ethernet port addresses are:
 TSEC_1 MAC address is: 0x00 0x80 0xF9 0x97 0x00 0x20
 TSEC_2 MAC address is: 0x00 0x80 0xF9 0x98 0x00 0x20
6.3.1 Front Panel Ethernet Ports
One MPC8548 PHY (TSEC1) routes to front panel RJ45 connector, P1. The BCM56802 switch
PHY (port 3) routes to front panel RJ45 connector, P3. The Ethernet port LEDs (green or yellow)
indicate link and activity status, see front panel
Figure 2-1 .
Table 6-3 Ethernet Port Address
Offset MAC Description Ethernet Identifier (hex)
Byte 5 15:0 LSB of (serial number in hex) -
Byte 4 MSB of (serial number in hex) -
Byte 3 23:16 Port 1 (TSEC_1)
Port 2 (TSEC_2) 0x97
0x98
Byte 2 47:24 Assigned to Artesyn by IEEE 0xF9
Byte 1 0x80
Byte 0 0x00
Table 6-4 Front Panel Ethernet Ports
Pin P1 Signal P3 Signal
1 TSEC1_TRD0_P FP1_TRD0_P