Artesyn ATCA-9305 User's Manual (May 2014) - Manual (Page 164)

System Management
ATCA-9305 User’s Manual (10009109-07) 164
7.10.4 Get FRU LED State Command
The Get FRU LED State command allows the state of the FRU LEDs to be controlled by the
management system.
Request Data 6 Color When Illuminated–sets the override color when LED Function is 01h-
FAh and FFh. This byte sets the Local Control color when LED Function is
FCh. This byte may be ignored during Lamp Test or may be used to control
the color during the lamp test when LED Function is FBh.
Bits [7:4] reserved, set to 0
Bits [3:0]
0h reserved
1h Use Blue
2h Use Red
3h Use Green
4h Use Amber
5h Use Orange
6h Use White
7h-Dh reserved
Eh Do not change
Fh Use default color
Response Data 1 Completion Code
2 PICMG Identifier–indicates that this is a PICMG defined group extension
command. Use value 00h.
Table 7-14 Set FRU LED State Command (continued)
Type Byte Data Field
Table 7-15 Get FRU LED State Command
Type Byte Data Field
Request Data 1 PICMG Identifier—indicates that this is a PICMG defined group extension
command. Use value 00h.
2 FRU Device ID