Artesyn ATCA-9305 User's Manual (May 2014) - Manual (Page 249)

Management Processor Monitor
ATCA-9305 User’s Manual (10009109-07) 249
Definition
Set the environment variable name to value or adds the new variable name and value to the
environment.
setenv name value
Removes the environment variable name from the environment.
setenv name
9.13 Test Commands
The commands described in this section perform diagnostic and memory tests.
9.13.1 diags
The diags command runs the Power-on Self-test (POST).
Definition
diags
9.13.2 mtest
The mtest command performs a simple SDRAM read/write test.
Definition
mtest [start [end [pattern]]]
9.13.3 um
The um command is a destructive memory test. Press the ‘q’ key to quit this test; the monitor
completes running the most recent iteration, and exits to the default prompt after displaying
cumulative results for the completed iterations.
Definition