8 oem boot options, Table 7-6, Artesyn boot option parameters – Artesyn ATCA-9305 User's Manual (May 2014) User Manual
Page 150: System management

System Management
ATCA-9305 User’s Manual (10009109-07)
150
7.8
OEM Boot Options
The Set System Boot Options and Get System Boot Options commands provide a means to
set/retrieve the boot options. The IPMI specification defines a set of standard boot option
parameters. In addition, the specification includes a range of numbers (96-127) for OEM
extensions. Artesyn utilizes this area for OEM function extensions, such as boot bank selection,
POST configuration, Graceful Shutdown Timeout, and Boot Firmware Boot Options. The
following table describes these extensions:
Table 7-6 Artesyn Boot Option Parameters
Parameter
#
Parameter Data
Boot Bank
(non-volatile)
96
data 1 — Set Selector. This is the processor ID for which the boot option
is to be set.
data 2 — Boot Bank Selector. This parameter is used to indicate the boot
bank from which the payload will boot.
00h = Primary (i.e., default) Boot Bank is selected.
01h = Secondary Boot Bank is selected.
02h = PLCC32 Socket is selected.
03h-FFh = unused
POST Type
(non-volatile)
97
data 1 — Set Selector. This is the processor ID for which the boot option
is to be set.
data 2 — POST Type Selector. This parameter is used to specify the POST
type that the payload boot firmware will execute.
00h = Short POST
01h = Short POST
02h-FFh = unused
Graceful Shutdown
(nonvolatile)
98
The value of Graceful Shutdown Timeout specifies a timer to be used by
the IPMC to know how long it has to wait for the payload to shut down
gracefully. If payload software does not configure its OpenIPMI library
to be notified for graceful shutdown requests, the IPMC shuts down the
payload when the timer expires.
data 1 - LSB of graceful shutdown timeout value in 100 ms
data 2 - MSB of graceful shutdown timeout value in 100 ms