Artesyn ATCA-9305 User's Manual (May 2014) - Manual (Page 243)

Management Processor Monitor
ATCA-9305 User’s Manual (10009109-07) 243
Definition
imw chip address[.0, .1, .2] value [count]
9.10.7 inm
The inm command modifies I
2
C memory, reads it, and keeps the address.
Definition
inm chip address[.0, .1, .2]
9.10.8 iprobe
The iprobe command probes to discover valid primary I 2 C bus chip addresses.
Definition
iprobe
9.11 IPMC Commands
IPMI Baseboard Management Controller (BMC) watchdog is supported and serviced
throughout the monitor boot process. The BMC watchdog is disabled if the monitor goes to
the monitor prompt.
9.11.1 bootdev
The bootdev command gets or sets the initial boot bank. Get prints out the flash bank set as
initial boot device.
Definition
bootdev get
The IPMC sets the hardware strapping for the initial boot device.
bootdev set