Artesyn ATCA-9305 User's Manual (May 2014) - Manual (Page 167)

System Management
ATCA-9305 User’s Manual (10009109-07) 167
7.11 Vendor Commands
The IPMC supports additional IPMI commands that are specific to Pigeon Point and/or Artesyn.
This section provides detailed descriptions of those extension or SIPL commands.
Response Data 10 Lamp Test Duration–is optional if Lamp Test is not in effect (hundreds of
milliseconds).
Table 7-15 Get FRU LED State Command (continued)
Type Byte Data Field
Table 7-16 Vendor Command Summary
Command netFn LUN Cmd
Get Status OEM 2E, 2F 00
Get Serial Interface Properties OEM 2E, 2F 01
Set Serial Interface Properties OEM 2E, 2F 02
Get Debug Level OEM 2E, 2F 03
Set Debug Level OEM 2E, 2F 04
Get Hardware Address OEM 2E, 2F 05
Set Hardware Address OEM 2E, 2F 06
Get Handle Switch OEM 2E, 2F 07
Set Handle Switch OEM 2E, 2F 08
Get Payload Communication Time-Out OEM 2E, 2F 09
Set Payload Communication Time-Out OEM 2E, 2F 0A
Enable Payload Control OEM 2E, 2F 0B
Disable Payload Control OEM 2E, 2F 0C
Reset IPMC OEM 2E, 2F 0D
Hang IPMC OEM 2E, 2F 0E
Bused Resource Control OEM 2E, 2F 0F
Bused Resource Status OEM 2E, 2F 10
Graceful Reset OEM 2E, 2F 11