Artesyn ATCA-9305 User's Manual (May 2014) - Manual (Page 201)

System Management
ATCA-9305 User’s Manual (10009109-07) 201
7.17 System Firmware Progress Sensor
The Update System Firmware Progress Sensor command sets the values for the Firmware
Progress Sensor using sensor codes from the IPMI Intelligent Platform Management Interface
Specification, specifically (System Firmware Progress” within Table 42-3 in Section 42.2
“Sensor Type Codes and Data.”)
The command returns 0xC0 when the IPMC is busy and will retry until the command is
successful. If this command returns 0xCC, the sensor ID is invalid. There is only one sensor on
the board, so the sensor ID should always be “0”. When updated, the shelf manager is notified.
19 Network function for listener 7
20 Command for listener 7
Table 7-45 Get Message Listener List Command (continued)
Type Byte Data Field
Table 7-46 Update System Firmware Progress Sensor Command
Type Byte Data Field
Request Data 1:3 Artesyn Embedded Technologies - Embedded Computing Inc. IANA Private
Enterprise ID
0x0065CD = 26061 (Artesyn Embedded Technologies - Embedded
Computing Inc.)
LSB Byte first:byte 1 = CD, byte 2 = 65, byte 3 = 00
4 0 (The sensor ID)
5 Flags: reserved to 0
6 Offset in specification Valid offsets: 0, 1, 2
7 Event Data 2; content to be added into the second byte of event data
per the IPMI specification
Response Data 1 Completion Code
2:4 Artesyn Embedded Technologies - Embedded Computing Inc. IANA Private
Enterprise ID
0x0065CD = 26061 (Artesyn Embedded Technologies - Embedded
Computing Inc.)
LSB Byte first:byte 2 = CD, byte 3 = 65, byte 4 = 00