Artesyn ATCA-9305 User's Manual (May 2014) - Manual (Page 168)

System Management
ATCA-9305 User’s Manual (10009109-07) 168
7.11.1 Get Status
The IPMC firmware notifies the payload about changes of all status bits except for bits 0-2 by
sending an unprintable character (ASCII 07, BELL) over the Payload Interface. The payload is
expected to use the Get Status command to identify pending events and other SIPL commands
to provide a response (if necessary). The event notification character is sent in a synchronous
manner, and does not appear in the contents of SIPL messages sent to the payload.
Diagnostic Interrupt Results OEM 2E, 2F 12
Get Payload Shutdown Time-Out OEM 2E, 2F 15
Set Payload Shutdown Time-Out OEM 2E, 2F 16
Set Local FRU LED State OEM 2E, 2F 18
Get Local FRU LED State OEM 2E, 2F 19
Update Discrete Sensor OEM 2E, 2F 1A
Update Threshold Sensor OEM 2E, 2F 1B
Reserved for Message Listeners OEM 2E, 2F 17
Add Message Listener OEM 2E, 2F 18
Remove Message Listener OEM 2E, 2F 19
Get Message Listener List OEM 2E, 2F 1A
Update Firmware Progress Sensor OEM 2E, 2F F0
Table 7-16 Vendor Command Summary (continued)
Command netFn LUN Cmd
Table 7-17 Get Status Command
Type Byte Data Field
Request Data 1:3 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)