beautypg.com

4 bootp, 5 bootv, 4 bootp 9.6.5 bootv – Artesyn ATCA-9305 User's Manual (May 2014) User Manual

Page 230: Table 9-4, Static ip ethernet configuration, Management processor monitor

background image

Management Processor Monitor

ATCA-9305 User’s Manual (10009109-07)

230

9.6.4

bootp

The bootp command boots an image via a network connection using the BootP/TFTP protocol.
If loadaddress or bootfilename is not specified, the environment variables loadaddr
and bootfile are used as the default.

Definition

bootp [loadAddress] [bootfilename]

To use network download commands (e.g., bootp, bootvx, rarpboot, tftpboot), the
environment variables listed in

Table 9-4

must be configured. To set a static IP, these

environment variables must be specified through the command line interface.

9.6.5

bootv

The bootv command checks the checksum on the primary image (in flash) and boots it, if valid.
If it is not valid, it checks the checksum on the secondary image (in flash) and boots it, if valid.
If neither checksum is valid, the command returns back to the monitor prompt.

Definition

Verify bootup.

bootv

Write image to flash and update NVRAM.

Table 9-4 Static IP Ethernet Configuration

Environment Variable

Description

ipaddr

Local IP address for the board

serverip

TFTP/NFS server address

netmask

Net mask

gatewayip

Gateway IP address

ethport

eTSEC1 default

ethaddr

1

MAC address

Ensure that each MAC address on the network is unique.