beautypg.com

5 set debug level, Table 7-21, Set debug level command – Artesyn ATCA-9305 User's Manual (May 2014) User Manual

Page 175: System management

background image

System Management

ATCA-9305 User’s Manual (10009109-07)

175

7.11.5 Set Debug Level

The Set Debug Level command sets the current debug level of the IPMC firmware.

Table 7-21 Set Debug Level Command

Type

Byte

Data Field

Request Data

1:3

PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)

Request Data

4

Bits [7:5] reserved
Bit [4] IPMB Dump Enable
If set to 1, the IPMC provides a trace of IPMB messages that are arriving
to/going from the IPMC via IPMB-0 or IPMB-L
Bit [3] Payload Logging Enable
If set to 1, the IPMC provides a trace of SIPL activity on the Payload
interface onto the Serial Debug interface
Bit [2] Alert Logging Enable
If set to 1, the IPMC outputs important alert messages onto the Serial
Debug interface
Bit [1] Low-level Error Logging Enable
If set to 1, the IPMC outputs low-level error/diagnostic messages onto
the Serial Debug interface
Bit [0] Error Logging Enable
If set to 1, the IPMC outputs error/diagnostic messages onto the Serial
Debug interface

Response Data 1

Completion Code

2:4

PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)