Artesyn ATCA-9305 User's Manual (May 2014) - Manual (Page 147)

System Management
ATCA-9305 User’s Manual (10009109-07) 147
7.7 Standard Commands
The Intelligent Peripheral Management Controller (IPMC) supports standard IPMI commands
to query board information and to control the behavior of the board. These commands provide
a means to:
 identify the controller
 reset the controller
 return the controller’s self-test results
 read and write the controller’s SROMs
 read the temperature, voltage, and watchdog sensors
 get specific information, such as thresholds, for each sensor
 read and write the Field Replaceable Unit (FRU) data
 reserve and read the Sensor Data Record (SDR) repository
 configure event broadcasts
 bridge an IPMI request to the public IPMB and return the response
Table 7-5 lists the IPMI commands supported by the IPMC along with the hexadecimal values
for each command’s Network Function Code (netFn), Logical Unit Number (LUN), and
Command Code (Cmd):
Table 7-5 IPMC IPMI Commands
Command netFn LUN Cmd
Set System Boot Options Chassis 01, 01 07
Get System Boot Options Chassis 01, 01 08
Set Event Receiver Sensor/Event 04, 05 00
Get Event Receiver Sensor/Event 04, 05 01
Platform Event (Event Message) Sensor/Event 04, 05 02
Get Device SDR Information Sensor/Event 04, 05 20
Get Device SDR Sensor/Event 04, 05 21
Reserve Device SDR Repository Sensor/Event 04, 05 22