SilentKnight 5820XL - Manual (Page 179)

Model 5820XL / 5820XL-EVS Installation Manual LS10061-001SK-E
9-15
6. Select option 2 Local Recording.
Note: The VCM will light the green Select Key LED for message slots that are occupied. If a message is already
stored in the desired slot, then you must erase the message first. (see 9.10.3).
7. Select the amplifier and circuit for the audio to play through during programming. A user would generally
pick the audio circuit that is in closest proximity to them.
8. Press EVS Message Key 1 to enter the message slot selection mode. Then, press the Select Key 1-15 that
corresponds to the message slot that you wish to record to. The associated Select Key red LED will begin
flashing, indicating that the message slot is ready for recording.
9. Simultaneously press EVS Message Key 3 and start playing the audio source on the PC or laptop.
10. When the audio file from the PC is finished playing, press EVS Message Key 3 again to stop the recording.
The Select Key green LED will come on.
11. To playback the recorded message, press the Select Key 1-15 that was just recorded to.
Recording with Aux Audio Input Example:
The user wants to record into memory slot 2 via the Aux Audio Input channel.
Upon entering the Local Recording mode via the keypad menu, the VCM will light the Select Key green LEDs
1-15 for each occupied message slot.
If a message already exists in message slot 2, it must first be erased. Press EVS Message Key 8, then press Select
Key 2, (see Section 9.10.3). When the message has been erased Select Key 2’s green LED will turn off.
To record a message, press EVS Message Key 1, then press Select Key 2 (this will use message slot 2 for the
recording). Select Key 2's red LED will begin flashing.
Press EVS Message Key 3 while simultaneously pressing play on the PC to start recording the Aux Audio Input.
When the PC message is done, press EVS Message Key 3 to stop recording. Select Key 2's red LED will stay on
until processing is completed. Select Key 2's green LED comes on after the recording is completed.
Pressing Select Key 2 will start a playback of the recorded message.
Figure 9-8 Aux Audio Input Example
Press
Press EVS
Select Key 2
to record
Message to
this slot
Press EVS
Message Key
1 to enter message
slot selection mode
Message Key 3
to start and stop
recording from
the Aux Audio
Input