8 slc family, 7 jumpstart autoprogramming, Jumpstart autoprogramming – SilentKnight 5820XL User Manual
Page 140: E 7.7, Section 7.6.8, Section 7.7
LS10061-001SK-E
Programming
7-32
7.
When done, press ENTER to move to line two of the custom banner. Repeat step 6 and 7.
7.6.8
SLC Family
The 5820XL / 5820XL-EVS supports SD protocol SLC devices or Intelligent Device Protocol (SK) SLC
devices. You must configure the 5820XL / 5820XL-EVS to accept the protocol of the devices you are installing.
You cannot mix SLC devices of different protocols.
1.
Enter the installer code. The panel will automatically go to the main menu.
2.
Select 7 for Program Menu.
3.
Select 5 for System Options.
4.
Press 9 for SLC Family.
5.
Press the Up arrow to select the desired SLC device type.
6.
Press enter
to accept the displayed SLC device type.
7.7
JumpStart Autoprogramming
To run JumpStart:
1.
Enter the installer code. The panel will automatically go to the main menu.
2.
Select 7 for Program Menu.
3.
Select 6 for System Options.
4.
Press the
or
arrow to select “Yes” from the warning screen.
5.
Press ENTER.
IMPORTANT!
JumpStart is intended to be used prior to performing any custom programming. Each time JumpStart is
executed, all options will be reset to their default values. Do not run JumpStart after you have configured the
system through programming.