SilentKnight 5820XL - Manual (Page 160)

LS10061-001SK-E System Operation
8-14
Prealarm
A single detector
trips in a 2-Count
zone. (2- Count
means two
detectors must trip
before an alarm is
reported.) Touchpad PZT beeps. The LCD displays a
screen similar to this one. Press down arrow to view the prealarm. A
screen similar to this one displays.
All system operations are available in this
mode. After sitting idle, evens will display
on a screen similar to this:
Reset (Fire
Alarm Only) The RESET button
is pressed followed
by a valid code or
rotation of the key All LEDs are on briefly then the LCD displays
“RESET IN PROGRESS”. If the reset
process completes normally, the date and
time normal mode screen displays. Menus are not available during the reset
process.
Reset (EVS and
Fire) The RESET button
is pressed. All LEDs are on briefly then the LCD displays
“RESET IN PROGRESS”. If the reset
process completes normally, the date and
time normal mode screen displays. Menus are not available during the reset
process.
Silenced (EVS
and Fire) An alarm or trouble
condition has been
silenced but still
exists. To silence
alarms and troubles,
press SILENCE
followed by the
Installer or User
Code or rotate the
key. SYSTEM SILENCE LED is on. SYSTEM
TROUBLE, SUPERVISORY or GENERAL
ALARM LED (depending on condition) is on.
The annunciator (and any notification
devices attached to the system) will be
silenced. Press down arrow to view the location of
the alarm or trouble. When the condition no
longer exists, the SYSTEM SILENCED and
SYSTEM TROUBLE LED, SUPERVISORY
or GENERAL ALARM LEDs turn off.
Table 8-1
Operation
Mode Occurs When
System Behavior In This Mode You Can