SilentKnight 5820XL - Manual (Page 173)

Model 5820XL / 5820XL-EVS Installation Manual LS10061-001SK-E
9-9
During JumpStart, the EVS-VCM is automatically associated with the internal annunciator. The association for
other LOCs in the system must be performed in programming.
9.7 Amplifier Programming
9.7.1 Adding an Amplifier
To add a new amplifier to the system, follow these steps:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Program Menu.
3. Press 1 to enter Module menu.
4. Press 2 to add a module.
5. From the next screen, select desired amplifier.
The screen will display “Adding module [#]...” for a few moments. You will be
returned to the screen where you can select another module if desired.
You must save changes when you exit the Program Menu or the new module will not be added. For more
information see section 7.2.2.
If you Add a Module that has not been physically connected, the panel will go into trouble after it re-initial-
izes (when you exit the Program Menu). When the new module is attached, the trouble will restore automat-
ically the next time you power up the system.
9.7.2 Editing an Amplifier
When editing amplifiers, the features that may be edited are (dependent upon amplifier model): module ID,
module name, CE4 Exp installed (Yes or No), output voltage, and amp mode. To edit an existing module:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Program Menu.
3. Press 1 to enter Module menu.
4. Press 1 to edit a module.
5. Use the or arrow to select the module you wish to edit.
6. Press the or ENTER to move to the next selection.