SilentKnight 5820XL - Manual (Page 111)

Model 5820XL / 5820XL-EVS Installation Manual LS10061-001SK-E
7-3
5. From the next screen, use the or arrow to choose a module type to add from the
Type> screen.
The screen will display “Adding module [#]...” for a few moments. You will be returned to the ule Type> screen where you can add additional modules if desired.
You must save changes when you exit the Program Menu or the new module will not be added.
Note: If you Add a Module that has not been physically connected, the panel will go into trouble after it reinitial-
izes (when you exit the Program Menu). When the new module is attached, the trouble will correct itself
automatically the next time you power up the system.
7.2.3 Deleting a Module
To delete a module, follow these steps:
You must be in the Main Menu to perform this task. If necessary, enter the Installer Code.
1. Enter the installer code. The panel will automatically go the main menu.
2. Select 7 for Program Menu.
3. Press 1 to enter module menu.
4. Select module to be deleted.
5. Press 3 to delete a module.
6. A warning screen will display. If you want to proceed with deleting the module, select Yes. To cancel, select
No.
7.2.4 View Module List
To view a list of all modules, follow these steps:
1. Enter the installer code. The panel will automatically go the main menu.
2. Select 7 for Program Menu.
3. Press 1 to enter module menu.
4. Press 4 to view module list.
7.3 Zone
Through the zone option in the program menu you can edit, add, delete, and view zone points. Selections made
here affect all detectors and switches in the zone. Up to 125 zones can be used in the system.
7.3.1 Edit Zone
Features that can be edited through the edit zone option are zone name, zone properties (which includes zone
type and detector sensitivity), zone output mapping, and zone accessory options.
To edit a zone, follow these steps:
1. Enter the installer code. The panel will automatically go the main menu.
2. Select 7 for Program Menu.
3. Press 2 to enter zone menu.
4. Press 1 to edit a zone.
5. Enter the zone number, then press ENTER.