SilentKnight 5820XL - Manual (Page 138)

LS10061-001SK-E Programming
7-30
Note: See Section 7.3.1.4 for more information about Synchronization protocol choices.
7.6.5.2 Auto Display Oldest Event
When this feature is programmed Y (Yes) then the oldest un-acknowledge event will automatically display on
the control panel and remote annunciators after there has been no activity on any system touchpad for two
minutes.
7. Press the or arrow to toggle this selection between Y (Yes) or N (No).
8. Press the right arrow or ENTER to make your selection and move to the next programming option.
7.6.5.3 Report by Zone or by Point
When the “Report by” option is set to Zone, then the control panel will report events by zone. If Point is selected
then the control panel will report events by point.
9. Press the or arrow to toggle this selection between Zone or Point.
10. Then press the right arrow or ENTER. See Section 10 for reporting codes.
7.6.5.4 Plex Door Option
If installing the plex door hardware (PN Plex-1), you must turn the Plex Door option On as described in this
section.
To turn the Plex Door option on/off:
11. Press the or arrow to toggle this selection between Y (Yes) or N (No).
12. Press the right arrow or ENTER to make your selection and move to the next programming option.
7.6.5.5 Single Key Acknowledge
When this feature is programmed Y (Yes) it allows the user to press the ENTER and display the oldest un-
acknowledged event in the system. Pressing ENTER again will acknowledge the event, then display the next
oldest un-acknowledge event without pressing the or arrow keys.
7.6.6 Daylight Savings
To edit Daylight Savings:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Program Menu.
3. Select 5 for System Options.
4. Select 7 for Daylight Savings.
7.6.6.1 Automatic Daylight Savings Adjustment
The control panel has an automatic DST (Daylight Saving Time) adjustment feature. Before January 2007, if this
feature is enabled (set to Yes), the system clock will switch to DST on the first Sunday in April at 2:00 a.m. and
revert to standard time on the last Sunday in October at 2:00 a.m. After January 2007, if this feature is enabled,
the system clock will start and end DST according to the settings made in Daylight Savings (see Section 7.6.6.2).
If this feature is not enabled (set to No) the Daylight Saving Time change is not made to the system clock.
To enable or disable DST adjustment continue programming from step 4 above:
5. Select Y (enabled) or N (disabled) by pressing the or arrow, then press ENTER.
7.6.6.2 Daylight Saving Time Start and End
This option lets you to adjust the week and month Daylight Saving Time (DST) starts and ends. For this feature
to work, you must enable (set to Yes) the DST option under Daylight Savings (see Section 7.6.6.1). You can view
and change the settings in this option anytime, however, settings will not take effect until 2007. The default