SilentKnight 5820XL - Manual (Page 157)

Model 5820XL / 5820XL-EVS Installation Manual LS10061-001SK-E
8-11
Alarm
A smoke detector
goes into alarm or a
pull station is
activated.
CO Detector goes
into Alarm.
EVS LOC or point
alarm.
If more than 3
categories are
active at a single
time and EVS is
enabled, top screen
will display. If EVS in
not enabled, it will
look like bottom
screen.
The dialer seizes control of the phone line
and calls the central station. The on-board
annunciator sounds a loud, steady beep (any
notification devices attached to the system
will also sound).
GENERAL ALARM LED flashes.
The LCD displays a screen similar to this
one. Press the down arrow to view the alarm. A
screen similar to this one displays.
.
Press SILENCE and enter an access code
(or activate the key) to silence the
annunciator (and any notification devices
attached to the system). When the alarm
condition clears, press RESET and enter a
code (or activate the key) to restore the
panel to normal. After sitting idle, events
will display in a screen similar to this:
Note: Alarm and Prealarm are com-
bines into single alarm count.
Table 8-1
Operation
Mode Occurs When
System Behavior In This Mode You Can