Rockwell Automation 2100-GK61 DeviceNet to SCANport - Manual (Page 66)

Publication 2100-UM001B-EN-P – January 2001
4-30 Configuring a Scanner to Communicate with the Adapter
Figure 4.40
“Save As” Dialog Screen
Your device is now configured on the DeviceNet network. The
network LED on the module is solid green. If it is not, refer to
Chapter 7, Troubleshooting, for more information.
Refer to Chapter 5, Ladder Logic Programming—Including Reading
Inputs, for information on creating a Ladder Logic Program.
Configuring a ControlLogix
Scanner (1756-DNB) to
Communicate with the Adapter The following instructions describe how to configure a ControlLogix
scanner on a DeviceNet network.
For the ControlLogix to recognize your device, you must do the
following:
• Configure the ControlLogix scanner.
• Map your adapter to the ControlLogix scanner (1756-DBN).
To configure the scanner, you verify its properties, add devices on the
network to its scan list, and determine how the scanner will
communicate (e.g., polling) with each device. Follow these
directions:
1. In the Online screen, double-click on the scanner icon. The
1756-DBN Scanner Module properties and configuration screen
appears.
Step #19
Step #19