Rockwell Automation 2100-GK61 DeviceNet to SCANport - Manual (Page 147)

Publication 2100-UM001B-EN-P – January 2001
DeviceNet to SCANport Communication Module with Digital Inputs Parameters B-21
26 COS Status
Mask
0 or 1 for each
bit
0 Yes No Provides a mask of the Logic Status word to
define which bits are checked for changes
during COS allocation.
0 = Off (not checked).
1 = On (checked).
Important: Refer to your SCANport product’s
documentation for information on its Logic
Status word.
27 COS Feed-
back Change
0 = disable 0 = dis-
able
Yes No Determines how much (+/-) the feedback word
can change before a message is sent during
COS operations.
28 COS/Cyc
Interval
N/A N/A No No Displays the interval used by the controller to
check for data in the adapter during COS or
Cyclic allocation.
29 Peer A Input Off,
Cmd/Ref
DL A Input
DL B Input
DL C Input
DL D Input
Off Yes No Determines where the peer A input is sent in the
SCANport product.
Important: This parameter cannot be changed
when the Peer Inp Enable (36) parameter is On.
30 Peer B Input Off
Cmd/Ref
DL A Input
DL B Input
DL C Input
DL D Input
Off Yes No Determines where the peer B input is sent in the
SCANport product.
Important: This parameter cannot be changed
when the Peer Inp Enable (36) parameter is On.
31 Peer Cmd
Mask
0 or 1 for each
bit
0 Yes Yes Provides a mask for the Logic Status word
when it is received through peer input.
0 = Off (input received from Master).
1 = On (input received from Peer).
32 Peer Ref
Adjust
0-200.00% 0 Yes No Provides the percentage of the Reference value
received through peer input that will be applied
to the SCANport reference value.
# Name
Valid Values/
Settings
Default Writable
Reset or
Power
Cycle
Description
Important: For information on accessing and editing parameters, refer to Chapter 3, Configuring the DeviceNet to SCANport
Communication Module with Digital Inputs.