Rockwell Automation 2100-GK61 DeviceNet to SCANport - Manual (Page 30)

Publication 2100-UM001B-EN-P – January 2001
2-10 Installation
Your 2100-GK61 module is now installed. The SCANport LED is
green. The network and module LEDs are blinking green. If your
module’s LEDs are different, refer to Chapter 7, Troubleshooting, for
more information.
You must now edit the adapter’s node address, and you may want to
edit some of its other parameters. Refer to Chapter 3 for more
information.
Removing the DeviceNet to SCANport
Communication Module with Digital Inputs
(2100-GK61)
To remove the DeviceNet to SCANport Communication Module with
Digital Inputs, you need to:
1. Disconnect Input Power from Digital Inputs.
2. Remove the SCANport cable from the SCANport product and
then from the module.
3. Unplug the 10-pin DeviceNet connector from the module.
4. Unplug the 6-pin Digital Input connector from the module.
5. Remove the module from the panel.
!
ATTENTION: Electrical shock hazard exists if
power is not disconnected to Digital Input Devices.
Verify power is removed before proceeding.