Rockwell Automation 2100-GK61 DeviceNet to SCANport - Manual (Page 152)

Publication 2100-UM001B-EN-P – January 2001
B-26 DeviceNet to SCANport Communication Module with Digital Inputs Parameters
M-S Output Parameter Configurations
The M-S Output parameter has the following five configurable bits.
Figure 7.3
Bits and Corresponding I/O
When you enable the Cmd/Stat (4) or datalink (5-8) parameter(s) in
the adapter, you must set the corresponding bit in the M-S Output (25)
parameter if you want the output data to be sent to the scanner or
master device.
01110 xxxx1 6 6 6 6/0 6/0
01111 xxxx1 8 8 8 8/0 8/0
10000 xxxx1 2 2 2 2/0 2/0
10001 xxxx1 4 4 4 4/0 4/0
10010 xxxx1 4 4 4 4/0 4/0
10011 xxxx1 6 6 6 6/0 6/0
10100 xxxx1 4 4 4 4/0 4/0
10101 xxxx1 6 6 6 6/0 6/0
10110 xxxx1 6 6 6 6/0 6/0
10111 xxxx1 8 8 8 8/0 8/0
11000 xxxx1 4 4 4 4/0 4/0
11001 xxxx1 6 6 6 6/0 6/0
11011 xxxx1 8 8 8 8/0 8/0
11100 xxxx1 6 6 6 6/0 6/0
11101 xxxx1 8 8 8 8/0 8/0
11110 xxxx1 8 8 8 8/0 8/0
11111 xxxx1 10 10 10 10/0 10/0
ADAPTER
CONFIGURATION
ALLOCATION (Number Of Words)
Data Size Sent From The Controller To The Adapter
M-S Input
M-S
Output
Poll Only COS Only
Cyclic
Only
Poll &
COS
Poll &
Cyclic
xxx0, 0 0 0 0
datalink D
datalink C
datalink B
datalink A
Stat/Fdbk
0 = Peer or other
output