Rockwell Automation 2100-GK61 DeviceNet to SCANport - Manual (Page 21)

Publication 2100-UM001B-EN-P – January 2001
Chapter
2
Installation
Chapter Objectives Chapter 2 provides the information that you need to install the
2100-GK61 module. In this chapter, you will read about the
following:
• Required tools and equipment.
• Selecting cables.
• Installing the adapter.
• Removing the adapter.
Installing a 2100-GK61 Module Follow these procedures to install a 2100-GK61 module.
Required Tools and Equipment
To install your 2100-GK61 module, you will need the following tools
and equipment:
• DeviceNet to SCANport Communication Module with Digital
Inputs(2100-GK61).
• A 6-pin and 10-pin plug-in connector (supplied with module).
• Screwdriver or nutdriver and mounting screws (#10).
• Appropriate cables for SCANport and DeviceNet connections.
Refer to the “Selecting Cables” section below.
Selecting Cables
To connect the 2100-GK61 to the SCANport product and the
DeviceNet network, you must select an appropriate DeviceNet cable
and Allen-Bradley SCANport cable. Use the following information to
select appropriate cables for each connection.