Allied Telesis AT-S62 - Manual (Page 95)

95
Chapter 5
Simple Network Time Protocol (SNTP)
Commands
This chapter contains the following commands:
ˆ “ADD SNTPSERVER PEER|IPADDRESS” on page 96
ˆ “DELETE SNTPSERVER PEER|IPADDRESS” on page 97
ˆ “DISABLE SNTP” on page 98
ˆ “ENABLE SNTP” on page 99
ˆ “PURGE SNTP” on page 100
ˆ “SET DATE” on page 101
ˆ “SET SNTP” on page 102
ˆ “SET TIME” on page 103
ˆ “SHOW SNTP” on page 104
ˆ “SHOW TIME” on page 106
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
For background information on SNTP, refer to Chapter 3, “Basic
Switch Parameters” in the AT-S62 Management Software Menus
Interface User’s Guide.