Allied Telesis AT-S62 - Manual (Page 333)

AT-S62 Management Software Command Line Interface User’s Guide
Section II: Advanced Operations 333
SHOW QOS CONFIG
Syntax
show qos config
Parameters
None.
Description
Displays the CoS priority queues and scheduling. Figure 32 is an example
of the information displayed by this command.
Figure 32. SHOW QOS CONFIG Command
The current mapping of CoS priorities to port egress queues is displayed
in the top section. As an example, at the default setting packets with a CoS
priority of 3 are stored in egress queue 1 of a port.
The bottom section of the display shows the scheduling method of the
switch ports. In strict priority, a port transmits all packets out of the higher
priority queues before transmitting any from the low priority queues. This is
the default. In weighted round robin, a port transmits a set number of
packets from each queue. The weights only show a value when a port is
using weighted round robin and specify how many packets a port transmits
from a queue before moving to the next queue.
QoS Configuration information:
Number of CoS Queues .......... 8
CoS 0 Priority Queue .......... Q1
CoS 1 Priority Queue .......... Q0
CoS 2 Priority Queue .......... Q0
CoS 3 Priority Queue .......... Q1
CoS 4 Priority Queue .......... Q2
CoS 5 Priority Queue .......... Q2
CoS 6 Priority Queue .......... Q3
CoS 7 Priority Queue .......... Q3
Scheduling Mode ............... Strict Priority
Queue 0 Weight ................ 0
Queue 1 Weight ................ 0
Queue 2 Weight ................ 0
Queue 3 Weight ................ 0