Allied Telesis AT-S62 - Manual (Page 20)

Preface
20
New Features History
AT-S62 Version
1.4.0
Table 1 lists the new features in version 1.4.0 of the AT-S62 management
software.
Table 1. New Features in AT-S62 Version 1.4.0
Change Chapter and Command
Basic Switch Commands
Modified the SHOW CONFIG DYN
command to display the parameter
settings of individual switch modules. Chapter 3, “Basic Switch Commands” on page 41
Modified command:
ˆ “SHOW CONFIG DYNAMIC” on page 72
Added a fan control feature for the
AT-8524POE switch. Chapter 3, “Basic Switch Commands” on page 41
New commands:
ˆ “SET SYSTEM FANCONTROL” on page 68
ˆ “SHOW SYSTEM FANCONTROL” on page 85
Quality of Service - Flow Groups and Traffic Classes
Added the following parameters to the
commands for creating and modifying
flow groups and traffic classes:
ˆ TOS parameter for replacing the
Type of Service (ToS) field of IPv4
packets.
ˆ MOVETOSTOPRIORITY
parameter for replacing the value in
the 802.1p priority field with the
value in the ToS priority field in
IPv4 packets.
ˆ MOVEPRIORITYTOTOS
parameter for replacing the value in
the ToS priority field with the
802.1p priority field in IPv4 packets.
Chapter 17, “Quality of Service (QoS) Commands” on
page 281
Modified commands:
ˆ “CREATE QOS FLOWGROUP” on page 285
ˆ “SET QOS FLOWGROUP” on page 307
ˆ “CREATE QOS TRAFFICCLASS” on page 295
ˆ “SET QOS TRAFFICCLASS” on page 314