Allied Telesis AT-S62 - Manual (Page 366)

Chapter 21: Power Over Ethernet Commands
366 Section II: Advanced Operations
SHOW POE STATUS
Syntax
show poe status [port= port ]
Parameter
port Specifies a port. You can specify more than one port at
a time. You can specify the ports individually (for
example, 5,7,22), as a range (for example, 18-23), or
both (for example, 1,5,14-22).
Description
Entering this command without specifying a port displays the following
PoE information:
ˆ Max Available Power - The total available power for PoE supplied by
the switch. This value is 400 W for the AT-8524POE switch.
ˆ Consumed Power - The amount of power being used by the powered
devices.
ˆ Available Power - The amount of power available for additional
powered devices.
ˆ Power Usage - The amount of power currently consumed by the
powered devices connected to the switch. The value is give as a
percentage of the total amount of power available.
ˆ Min Shutdown Voltage - The minimum threshold voltage at which the
switch shuts down PoE. If the power supply in the switch experiences
a problem and the output voltage drops below this value, the switch
shuts down PoE on all ports. This value is not adjustable.
ˆ Max Shutdown Voltage - The maximum threshold voltage at which the
switch shuts down PoE. If the power supply in the switch experiences
a problem and the output voltage exceeds this value, the switch shuts
down PoE on all ports. This value is not adjustable.
ˆ Summary of port status
Specifying a port in the command displays the following PoE information
about the port:
ˆ PoE Function - Whether PoE is enabled or disabled on the port. The
default setting is enabled. To enable or disable PoE on a port, refer to
“ENABLE POE PORT” on page 361 and “DISABLE POE PORT” on
page 360.
ˆ Power Status - Whether power is being supplied to the device. ON
means that the port is providing power to a powered device. OFF