Allied Telesis AT-S62 - Manual (Page 189)

AT-S62 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 189
SHOW LACP
Syntax
show lacp [port= port ] [aggregator] [machine= port ]
Parameter
port Specifies the port(s) to display. You can specify the
ports individually (for example, 5,7,22), as a range (for
example, 18-20), or both (for example, 1,14-16).
aggregator Displays information about the aggregators.
machine Specifies the LACP machine state for a port or ports on
the system.
Description
This command displays the configuration and/or machine states of the
ports, and/or the aggregators. Entering the command without any
parameters displays general LACP status information. Figure 18 illustrates
the information displayed by this command.
Figure 18. SHOW LACP Command
The command displayed the following information:
ˆ Status - Whether the LACP protocol is enabled or disabled on the
switch.
ˆ MAC Address - The MAC address of the switch.
ˆ Priority - The LACP system priority value assigned to the switch.
Status ...........................: Enable
Mac Address .......................: 00-21-46-A7-B4-43
Priority ........................: 0x0080
Collector delay ..................: 0 Seconds