Allied Telesis AT-S62 - Manual (Page 286)

Chapter 17: Quality of Service (QoS) Commands
286 Section II: Advanced Operations
remarkpriority Replaces the user priority value in the packets with the
new value specified with the PRIORITY parameter.
This parameter is ignored if the PRIORITY parameter is
omitted or set to NONE. Options are:
yes, on, true Replaces the user priority value in the
packets with the new value specified
with the PRIORITY parameter.
no, off, false Does not replace the user priority value
in the packets with the new value
specified in with the PRIORITY
parameter. This is the default.
tos Specifies a replacement value to write into the Type of
Service (ToS) field of IPv4 packets. The range is 0 to 7.
A new ToS value can be set at all three levels: flow
group, traffic class, and policy. A ToS value specified in
a flow group overrides a ToS value specified at the
traffic class or policy level.
movetostopriority Replaces the value in the 802.1p priority field with the
value in the ToS priority field on IPv4 packets. Options
are:
yes, on, true Replaces the value in the 802.1p priority
field with the value in the ToS priority
field on IPv4 packets.
no, off, false Does not replace the preexisting 802.1p
priority level This is the default.
moveprioritytotos Replaces the value in the ToS priority field with the
802.1p priority field on IPv4 packets. Options are:
yes, on, true Replaces the value in the ToS priority
field with the 802.1p priority field on IPv4
packets.
no, off, false Does not replace the ToS priority field.
This is the default.
classifierlist Specifies the classifiers to be assigned to the flow
group. Separate multiple classifiers with commas (e.g.,
4,7,8). The classifiers must already exist.